67 bronco

[onpier55]

Re: 67 bronco

Look what I found. What gage metal is the frame so I can repair this mess.

[onpier55]

Re: 67 bronco

Crumpled passenger apron.

[onpier55]

Re: 67 bronco

New passenger side apron in place.

[904Bronco]

Re: 67 bronco

New passenger side apron in place.
[ATTACH=CONFIG]32241[/ATTACH]

I am watching this part Karl, I may have to do this on the Drvrs side... Almost done with drivers floor.

[onpier55]

Re: 67 bronco

I am watching this part Karl, I may have to do this on the Drvrs side... Almost done with drivers floor.

It was a lot easier to do than the floor pan. I’m waiting to weld it in place until I get frame and suspension done and remounted. To make sure it aligns properly.

[onpier55]

Re: 67 bronco

Painting the frame.

[904Bronco]

Re: 67 bronco

Painting the frame.
[ATTACH=CONFIG]32242[/ATTACH]

Details? Paint? Rust encapsulator used? Did you blast it or Wire wheel? This is on my list to do...

[onpier55]

Re: 67 bronco

Details? Paint? Rust encapsulator used? Did you blast it or Wire wheel? This is on my list to do...

I wire wheeled it and used an Eastwood horizontal sander. I didn’t get exotic with paint. Used rust oleum rust converter primer and spray can enamel. I’m not going for a show vehicle. Also bought Eastwood’s internal frame coating. Haven’t sprayed it inside yet. I have to repair frame that is in earlier pic.

[onpier55]

Re: 67 bronco

This thing works great on the flat surfaces of the frame.

[904Bronco]

Re: 67 bronco

This thing works great on the flat surfaces of the frame.
[ATTACH=CONFIG]32244[/ATTACH]

Thanks for the feedback Karl... I have used a lot of Eastwood stuff before... And some of the stuff they will not ship into this State anymore

[onpier55]

Re: 67 bronco

Is there a kit rebuild from the axles out? Seals and bearings?

[904Bronco]

Re: 67 bronco

Is there a kit rebuild from the axles out? Seals and bearings?[ATTACH=CONFIG]32256[/ATTACH]

I bet if you called WH's they would put one together for you...

https://www.wildhorses4x4.com/category/bronco_Dana44

[onpier55]

Re: 67 bronco

I bet if you called WH's they would put one together for you...

https://www.wildhorses4x4.com/category/bronco_Dana44

They sure do seem to have everything I need. And they’ve received a lot of my $ too. lol.

[onpier55]

Re: 67 bronco

Removed the ball joints from the steering knuckles. Rented tool from O’REilly’s Tool worked great. Now to clean off fifty years of oil and rust.

[onpier55]

Re: 67 bronco