at the risk of sounding like an idiot......

[welndmn]

Re: at the risk of sounding like an idiot......

So far for the only aftermarket ball joint inner C manufacturers I've found are Solid Axle Industries and Dynatrac, both of which are designed for 3.125" tube. I'll just make a pair of adapters in the lathe and maybe add a couple gussets for good measure. Those inner Cs should be forged correct? Would you recommend pre and post heating and using sand or is that for cast only? Thanks for the help and criticism, I do appreciate it

You missed this

http://www.reidracing.biz/off-road-p...a-60-inner-c-1

Orange stuff is the only ones you need, everything else is lame. (yes, I'm basis as it's my friends company)
They are a local company too, out of Pleasant Hill

[jonasd]

Re: at the risk of sounding like an idiot......

I checked those out but those are kingpin, I'll be running ball joint

[jamesroney]

Re: at the risk of sounding like an idiot......

Might try to call Currie directly. They use F450 ball joint inner c's on their Rock Jock 60. The Rock Jock uses oddball 3 inch tubes, just like your fabbed housing...so you might be in luck.

No guarantees...but it might work for you???

[welndmn]

Re: at the risk of sounding like an idiot......

Doh, I missed that it was a ball joint axle.