Bronco Frame and Tub for sale

[CrazyVolts]

Selling my 1970 frame and my 1971 body. Ford 9 inch rear end. Dana 44 front end. drum brakes, auxiliary gas tank and rear gas tank, dash with VIN, new inner fender well sheet metal, drive shaft, 3 speed manual transmission, factory bumper, new inner rocker panel sheet metal.

$1000 or best offer.
email crazyvolts@gmail.com

[TBS-POPS]

Re: Bronco Frame and Tub for sale

Any title to go with???

[CrazyVolts]

Re: Bronco Frame and Tub for sale

Pops,

No title..

[Bronco Brian]

Re: Bronco Frame and Tub for sale

Where is it at also ??

[CrazyVolts]

Re: Bronco Frame and Tub for sale

Napa

[CageDave]

Re: Bronco Frame and Tub for sale

It appears to be located on his front porch.

[14Justice]

Re: Bronco Frame and Tub for sale

Marc? This tub might be in better shape than yours??? New metal included.... You might be able to make it more enticing to the wifee by saying lets go to Napa for the weekend and not tell her why you're draging the trailer! Just sayin'

[earlybronco72]

Re: Bronco Frame and Tub for sale

I was lookin at this, and it looks like I could use the good from that tub and the good from mine and make a good one. I just don't think I have the actual skills it would take, or time. If it had the title I would definitely have been more interested though.

Marc? This tub might be in better shape than yours??? New metal included.... You might be able to make it more enticing to the wifee by saying lets go to Napa for the weekend and not tell her why you're draging the trailer! Just sayin'

[DoubleXL]

Re: Bronco Frame and Tub for sale

I was lookin at this, and it looks like I could use the good from that tub and the good from mine and make a good one. I just don't think I have the actual skills it would take, or time. If it had the title I would definitely have been more interested though.

If you change your mind, I'll buy the frame from you..

[Efibroncoman]

Re: Bronco Frame and Tub for sale

I was lookin at this, and it looks like I could use the good from that tub and the good from mine and make a good one. I just don't think I have the actual skills it would take, or time. If it had the title I would definitely have been more interested though.

I could help you with the sheet metal work Marc. I replaced the taillight panel on my 1969 Mustang. The most important tools for a job like that are a measuring tape, various types of clamping pliers and a good spot weld drill. You'll also want to use weld thru primer.